- Joined
- Oct 4, 2008
- Messages
- 121
Hi there,
Does anyone know the best way to remove the turnable (ie. latest G3) heads? I don't think there's any glue in them.
I've followed the prescribed yank-harder-then-you-think-you-need-to method I read on MLParena, but the G3 started to warp at the neck under the pressure. So I decided not to use even more force and abandoned my attempts. But the one I tested on now has a bit of a wonky neck with a gap in some parts. Does this happen to alot of people?
I don't want to boil/heat one unless neccessary.
Should I be holding it differently when I pull? And what about angle of exertion etc? The warping is a pain!
Related question: Where can I find plastic tail rings? Want to replace some of the metal G3 ones.
Thanks in advance
Does anyone know the best way to remove the turnable (ie. latest G3) heads? I don't think there's any glue in them.
I've followed the prescribed yank-harder-then-you-think-you-need-to method I read on MLParena, but the G3 started to warp at the neck under the pressure. So I decided not to use even more force and abandoned my attempts. But the one I tested on now has a bit of a wonky neck with a gap in some parts. Does this happen to alot of people?
I don't want to boil/heat one unless neccessary.
Should I be holding it differently when I pull? And what about angle of exertion etc? The warping is a pain!
Related question: Where can I find plastic tail rings? Want to replace some of the metal G3 ones.
Thanks in advance